Wadjet Eye Games

Author Topic: help wth blueprints  (Read 4178 times)

Offline ruby

  • Newbie
  • *
  • Posts: 1
    • View Profile
help wth blueprints
« on: January 01, 2013, 01:39:23 PM »
Hello - Happy New Year,

please can someone help me - I'm not stuck on the blueprints.  my blueprints are in o15 and the will is at p17 - I've tried to figure this out and simply cant !
Thanks

Offline BigDes

  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: help wth blueprints
« Reply #1 on: January 02, 2013, 05:16:59 PM »
When you are using the machine first put it to M20, then save it.

The use it again and set it to N18 or L18.

You have to reset it to M20 every time you get it wrong though. So if it's not N18, set it to M20, save it then use the machine again and set it to L18.

Offline Rinu

  • Linux testers
  • Newbie
  • *
  • Posts: 7
    • View Profile
Re: help wth blueprints
« Reply #2 on: February 06, 2013, 03:46:08 AM »
Ruby, when you open the panel, it says that M20 serves for calibration. If the system is calibrated to M20 and you type P17, you'll get the will. If you calibrate it to M21 and you type P17, it tries to grab a stuff in P18. And so on.

Your goal is to calibrate it, so the system thinks it grabs P17 but it will grab O15. The best way to do it is to log into the panel, and move from P17 to O15 and mark the difference between two boxes. And then apply the metrics on M20.
After you're done, type P17 and it should give you blueprints stored in O15.
PC: i5 2400 3,1GHz, Gigabyte GA-Z68A-D3H, ATI Sapphire HD 6870 (non-proprietary drivers), 8GB DDR3 RAM + Ubuntu 12.04 64-bit up-to-date, Kernel 3.5.0-25-generic
NTB: Lenovo S205 + Ubuntu 12.04 32-bit up-to-date, proprietary drivers